Parts index / 5 results
Hydraulic filters
Compare the mounting, not just the silhouette. USD, applicable tax included.
UPU-F01 / Hydraulic filtersAn enclosed spin-on element with a threaded base and annular face gasket. Thread and gasket dimensions do not establish circuit suitability; confirm the housing specification before fulfilment.
- Construction
- Steel canister; enclosed pleated media; NBR base gasket
- Dimensions
- Height 145 mm; body diameter 93 mm; mounting thread 1–12 UNF; gasket ID 62 / OD 72 mm
UPU-F02 / Hydraulic filtersA replaceable pleated cartridge with an open central bore at both ends. Check housing length, core diameter, end-seat compression and seal material with the housing specification.
- Construction
- Pleated cellulose composite; steel end caps; NBR end seals
- Dimensions
- Length 200 mm; outside diameter 80 mm; open core 40 mm at both ends
UPU-F03 / Hydraulic filtersA mesh basket strainer with a threaded neck rather than pleated paper media. Check the suction assembly thread, clearance and service requirements; no mesh rating is asserted.
- Construction
- Stainless woven mesh; steel cage; threaded metal neck
- Dimensions
- Basket length 125 mm; diameter 70 mm; male neck thread 3/4 NPT; overall length 155 mm
UPU-F04 / Hydraulic filtersAn exposed pleated cartridge with a partial support sleeve, sealed lower spigot and additional side port. This is an element, not a pressure-rated housing. Confirm both port seats, housing geometry and circuit/media requirements before fulfilment.
- Construction
- Pleated synthetic composite; partial perforated steel support sleeve; NBR lower-spigot O-ring
- Dimensions
- Length 160 mm; outside diameter 60 mm; lower spigot 28 mm; side port outside diameter 18 mm; O-ring section 3 mm
UPU-F05 / Hydraulic filtersA compact vented tank-breather construction with a threaded base. It is not a replacement for a hydraulic flow-line element; confirm tank port, clearance and required breather specification.
- Construction
- Coated steel vent cap; pleated inner element; threaded base
- Dimensions
- Overall height 75 mm; cap diameter 65 mm; male base thread 1/2 NPT